Meitrack MDVR MD600
Introduction
Meitrack MD600
| Description | MD600 is the second generation of a new solution AI MDVR with high-performance AI processing chips |
|---|---|
| Date | 15 April 2025 |
| Location | PT. Bumi Suksesindo |
| Category | Fatigue Monitoring System |
| Additional Info | Hardware by Meitrack |
MD600 is the second generation of a new solution AI MDVR with high-performance AI processing chips, with a dual-system (dual communication channel), highly stable 6-channel AHD, and 1080P high-definition vehicle-mounted hard disk video recorder. It possesses high computing power and can support AI applications such as ADAS and DMS.
The product is based on a dual system of Linux operating system and MCU OS, incorporating advanced technologies including high-performance H.264/H.265 video compression/decompression, 4G, GPS, WiFi, Bluetooth, power-off data protection, wide voltage, high voltage protection, and other technologies. It serves as the core product of the next-generation wireless vehicle-mounted video surveillance solution.
Support 6-channel AHD720P/1080P cameras. Embedded high-performance AI video processing chip (optional AI video algorithm: ADAS, DMS). M.2 SSD, which is more suitable for low-temperature environments than conventional hard disks, supports up to 2TB hard disk, and comes with an SD card slot (up to 512G).
Adopt industrial grade power supply chip, support 11.4~36V wide range power input, adapt to the harsh environment. It supports dual working modes of local recording and network transmission. The built-in 6-axis sensor can be used for sharp turning, rapid acceleration, rapid deceleration, and other alarms. The self-developed data writing mechanism is adopted to effectively protect the video data and prevent data loss caused by abnormal power failure of the system.
Caution!!
Installation Environment
- To extend equipment life, please install the equipment in locations with little vibration.
- To ensure normal heat dissipation, do not install the device in a poorly-ventilated area (such as a trunk), and also keep it about 15 cm away from other objects on the same level.
- The device shall be horizonta lly installed and protected against water, humidity and lightning; in addition, keep the vehicle still during installation to prevent damage to the device due to falling off.
- To ensure safe operation, keep the device, camera, cables and other accessories out of reach of passengers and driver.
Spesification
| Power Supply | |
|---|---|
| Rated voltage | DC: 11.4 -36V. Rated at 12V/3A |
| Power consumption | The audio and video on the host is about 6W connected to 6 cameras, about
24W in the day (29W connected to the display), about 32W in the night (37W connected to the display), Connect to a single camera (normal range is 50mA~100mA during the day, 200mA~250mA at night) |
| AI | |
| AI video | ADAS. DMS |
| Storage media | |
| SD card and SSD hard drive | 1*M2 SSD and 2*SD, Capacity: 2 TB + 2* 512 GB, supports PCIe x2 and PCIe x4 NVME protocol M.2 NGFF SSD (2280 specifications) |
| System structure | |
| System operation | Dual system operation, dual communication channels (to prevent data loss) |
| Audio and video | |
| Video input | 6-channels AHD camera, can support D1/720P/1080P arbitrary mixing Adaptive camera resolution and format (PAL and NTSC) Maximum support 6x1080P@15fps real-time video recording |
| Video output | 1 channel VGA video output (8Pin aviation head interface), default resolution 1024*7681
1 CVBS aviation plug (level: 1.0Vp-p, impedance: 75Ω) Resolution: PAL 704*576, NTSC 704*480 |
| Compression standard | H.264/H.265 configurable |
| Image display | Support 1, 6 screen display |
| Audio input | 6 channels for the camera Mic input, the camera should support audio 1 way of intercom handle input 1 channel 3.5MM headphone interface input (GSM call interface) |
| Audio ouput | 1 independent audio isolation output (and connected to AV-OUT interface, VGA aviation head interface and intercom handle interface)1 channel 3.5MM headphone interface output (GSM call interface) |
| Audio compression | G.726/G.711a/AAC |
| Video request and Playback | It can retrieve and playback by channel, video type, bitstream type and time |
| Video Recording Method | Ordinary video and alarm video, sound and video recording synchronization |
| Frequency band | |
| MD600 | GSM: B3/B8
WCDMA: B1/B8 LTE-FDD: B1/B3/B7/B8/B20/B28 LTE-TDD: B38/B40 |
| WiFi/BLE/GNSS | |
| WiFi | IEEE 802.11b /g/n, frequency 2.4G&5.8G, supports STA and AP dual mode |
| Bluetooth | It supports master-slave dual mode, can read Bluetooth accessories, and can configure parameters through APP |
| Positioning mode | GPS/GPS_BEIDOU/GPS_GLONASS |
| Positioning accuracy | 2.5m |
| Tracking sensitivity | -162dBm |
| GNSS antenna | Support antenna insert/pull out/short circuit detection |
| Other | |
| SPI Memory | Built-in 64Mbit for storing GPRS\SMS\GPS LOG data |
| Operating temperature | Without battery: -20 to 70 degrees |
| Sensor | 6-axis acceleration sensor |
| I/O port | Main cable port: 8*Din(Max 8*Din) + 2*Dout(Max 8*Dout) + 2*AD(Max 6*AD) + 1*Speed_IN + 1*1-wire + 2*RS485 + 1*CAN + 1*DC_5V + 1*DC_12V
Other interfaces: 2-way RS232, 1-way ACC |
| Dimensions | Dimensions: 120*154*43mm |
| Weight | 740g (excluding accessories) |
| Certification | |
| Certification | CE Certification |
| Protocol | |
| Protocol | Meitrack Protocol (CCE) RTMP (Audio Video Transport Protocol, also compatible with Meitrack's Audio Video Private Transport Protocol) |
Front Host Interface
| No. | Interface | Signage | Description |
|---|---|---|---|
| 1 |
|
4G
REC PWR GPS ALM WIFI |
Green, network status indicator
Green, video status indicator Red, power supply status indication Blue, GPS status indicator Orange, video loss status indication Green, WIFI& Bluetooth status indicator |
| 2 | Microphone/speaker port | Audio | For external microphone \ speaker +GSM two-way calls |
| 3 | Infrared interface | IR | Infrared receiver (reserved function) |
| 4 | Debug interface | debug | Connect the PC side for parameter |
| 5 | SIM card | SIM | SIM card port |
| 6 | Lid detection switch | NA | Start work only when the lid is detected to have been installed |
| 7 | SD slot | SD | 2*SD card loading port |
| 8 | Electronic locks | Lock the sign | Lock the SD\SIM card, which is also the on/off machine for the device |
| 9 | ETH with USB interface | ETH & USB | Used to connect Ethernet for data transfer or parameter configuration. USB is used to upgrade the device and supports USB3.0 |
Rear Host Interface
| No. | Interface | Signage | Description |
|---|---|---|---|
| 1 | Power port | PWR & ACC | Red wire power 11.4~40V, rated 12V/3A; The black wire is GND.Yellow wire is connected to ACC high level detection, 3V effective, up to 40V |
| 2 | Serial Port 1 | RS232_1 | RS232_1: Used for external RFID, ultrasonic oil sensor and other peripherals |
| 3 | Serial Port 2 | RS232_2 | RS232_2: For extended connection peripherals such as G_MOSE |
| 4 | 24 PIN main cable | IO&AD&RS485&CAN | 8*Din(Max8*Din)+2*Dout(Max8*Dout)+2*AD(Max6*AD)+1*Speed
_IN+1*1-wire+2*RS232+2*RS485+1*CAN+1*DC_5V+1*DC_12V |
| 5 | 4G antenna port | 4G | 4G antenna access point |
| 6 | Bluetooth Antenna interface | BLE | Bluetooth antenna port |
| 7 | WiFi antenna interface | WIFI | WIFI antenna access point |
| 8 | GPS antenna interface | GNSS | GPS antenna access point |
| 9 | Video output | AV-OUT | Vehicle video CVBS output: Resolution -PAL 704*576,NTSC 704*480 |
| 10 | Video output | VGA | Vehicle video VGA output: Default output resolution 1280*720. |